Multi-tech-systems MULTIVOIP MVP210/410/810 Instrukcja Użytkownika Pobierz pdf (Strona 120)

Chapter 6: Using the Software

Multi-Tech Systems, Inc. 120

Downloading Factory Defaults

1. The MultiVOIP Configuration program must be off when invoking the Download Factory Defaults

command. If it is on, the command will not work.

2. To use the Download Factory Defaults command, go to Start | Programs | MultiVOIP x.xx. |

Download Factory Defaults.

3. If a password has been established, the Password Verification screen will appear.

Figure 6-18: Password verify

Type in the password and click OK.

4. The MVP x.xx - Firmware screen appears saying “MultiVOIP [model number] is up. Reboot to

Download Firmware?”

Click OK to download the factory defaults.

The “Boot” LED on the MultiVOIP will light up and remain lit during the file transfer process.

5. After the PC gets a response from the MultiVOIP, the Dialog – IP Parameters screen will appear.

Figure 6-19: Dialog screen

The user should verify that the correct IP parameter values are listed on the screen and revise them if

necessary. Then click OK.

6. Progress bars will appear at the bottom of the screen during the data transfer.

Figure 6-20: Progress bars

The MultiVOIP’s “Boot” LED will turn off at the end of the transfer.

7. The Download Factory Defaults procedure is complete.

1 2 ... 115 116 117 118 119 120 121 122 123 124 125 ... 143 144

Brak uwag

Multi-tech-systems MULTIVOIP MVP210/410/810 Instrukcja Użytkownika Strona 120